Automatic DB 5801 Manual de instrucciones

INSTRUCTION MANUALDB 5801250WMULTI TOOL

10OFF switch toward the front of the tool.2. To turn the tool OFF, press the rear part of the ON/OFF switch and allow the switch to slide to off pos

11Note: The tool and blade should be at a 45° angle to the oor to allow the corner of the blade to plunge cut into the ooring.5. While holding the

12accessories. Any such alteration or modication is misuse and could result in a hazardous condition leading to possible serious injury. It will also

13DISTRIBUTED BY;Global Power Brands International Pty. Ltd.PO Box 413 Mooroolbark VIC 3138ABN. 39 131 999 914Ph. 1800 909 909help@globalpowerbrands

2CONTENTSWarranty 3 Introduction 4

3desk will be borne by you! We will then, at our option, either repair or replace the product, or refund your money and take back the product - in acc

4IntroductionYour new AUTOMATIC power tool will more than satisfy your expectations. It has been manufactured under stringent AUTOMATIC Quality Standa

5increase the risk of electric shock.d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away

6measures reduce the risk of starting the power tool accidentally.d) Store idle power tools out of the reach of children and do not allow persons unf

7plug from the power source before installing or removing an accessory.Never use dull blades in the tool. They will cut slower, leave rough cuts and b

8UnpackingDue to modern mass production techniques, it is unlikely that your AUTOMATIC Power Tool is faulty or that a part is missing. If you nd anyt

9Notes: a) Check to make sure the convex curve of the washer is facing the head of the screw.b) Make sure the alignment holes in the blade are sti